LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Engine Oil Pressure Sensor Replacement (AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Oil Pressure Sensor And Electrical Connector
    GM4197202Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Component Fastener Tightening Caution

  1. Install and tighten Engine Oil Pressure Sensor (1) to 35 N.m (26 lb ft)
  2. Connect the electrical connector. (2)
  3. Install Power Transfer Unit Case. Refer to Power Transfer Unit Case Replacement (MHG Transmission with LH7 Engine)
  4. Lower the vehicle.
  5. Connect Battery Negative Cable. Refer to Battery Negative Cable Disconnection and Connection (KL9)
scientia non olet · About LEMON Manuals