LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (KL9)
  2. Remove Exhaust Gas Recirculation Cooler Housing. Refer to Exhaust Gas Recirculation Cooler Housing Replacement 
    3. Fig 1: Electrical Connector
    GM4375968Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the electrical connector. (1)
    4. Fig 2: Crankshaft Position Sensor, Bolt And Retainer Spring
    GM4375965Courtesy of GENERAL MOTORS COMPANY
  4. Remove Crankshaft Position Sensor Bolt (1)
  5. Remove Retainer Spring (3) @ Crankshaft Position Sensor (2)
    6. Fig 3: Crankshaft Position Sensor
    GM4375966Courtesy of GENERAL MOTORS COMPANY
  6. Remove Crankshaft Position Sensor (1)
scientia non olet · About LEMON Manuals