LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Charge Air Bypass Valve Vacuum Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect Battery Negative Cable. Refer to Battery Negative Cable Disconnection and Connection (KL9)
  2. Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement
    3. Fig 1: Engine Control Module Electrical Connectors And Harness Clips
    GM3221575Courtesy of GENERAL MOTORS COMPANY
  3. Unclip the 4 wiring harness clips (2, 3) from the bracket.
  4. Remove the engine control module bracket along with the engine control module in top direction from the battery tray.
  5. Disconnect the 3 engine control module electrical connectors (1) from the engine control module and hang it aside.
    6. Fig 2: Charge Air Bypass Valve Vacuum Hose And Components
    GM3288676Courtesy of GENERAL MOTORS COMPANY
  6. Remove the charge air bypass valve vacuum hose (2) from the exhaust gas recirculation vacuum regulator solenoid valve (1).
  7. Remove the charge air bypass valve vacuum hose (2) from the turbocharger wastegate actuator vacuum control solenoid valve (5).
  8. Remove the charge air bypass valve vacuum hose (2) from the charge air bypass regulator solenoid valve vacuum tube (4).
  9. Unclip the charge air bypass valve vacuum hose (2) clips from the brackets (3).
  10. Remove the charge air bypass valve vacuum hose (2).
scientia non olet · About LEMON Manuals