LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Strut Replacement (Front Wheel Drive) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission mount strut bracket. Refer to Transmission Mount Strut Bracket Replacement (Front Wheel Drive)
  2. Prior to removing the transmission strut, mark the transmission strut fasteners to transmission strut to sub frame interfaces using spray paint or a marker for correct positioning during installation.
  3. Using a suitable jack stand, support the rear of the powertrain.
    4. Fig 1: Transmission Strut, Nut And Bolt
    GM4663307Courtesy of GENERAL MOTORS COMPANY
  4. Remove the strut through bolt retaining nut (2).
  5. Remove and DISCARD the transmission strut through bolt (1).
  6. Remove the transmission strut (3).
scientia non olet · About LEMON Manuals