LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Strut Replacement (Front Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Transmission Strut, Nut And Bolt
    GM4663307Courtesy of GENERAL MOTORS COMPANY
  1. Using the outline made by the spray paint or marker, position the transmission strut (3) to the drivetrain and front suspension cradle.
    2. CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  2. Install the NEW transmission strut to bracket through bolt (1) and nut (2) then tighten to 100 N.m (74 lb ft) plus 120 to 135 degrees.
  3. Perform the Powertrain Mount Balancing - Lower procedure. Refer to the appropriate engine section.
  4. Remove the jack stand.
  5. Install the transmission mount strut bracket. Refer to Transmission Mount Strut Bracket Replacement (Front Wheel Drive)
scientia non olet · About LEMON Manuals