LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Strut Replacement (All Wheel Drive) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
  2. Prior to removing the transmission rear strut, mark the transmission rear strut fasteners to transmission rear strut to sub frame interfaces using spray paint or a marker for correct positioning during installation.
  3. Remove the two piece propeller shaft. Refer to Two-Piece Propeller Shaft Replacement
  4. Using a suitable jack stand, support the rear of the powertrain.
    5. Fig 1: Transmission Rear Strut And Bolts
    GM4572779Courtesy of GENERAL MOTORS COMPANY
  5. Remove and DISCARD the transmission rear strut through bolt (2).
  6. Remove and DISCARD the transmission rear strut to drivetrain and front suspension cradle bolt (1).
  7. Remove the transmission rear strut (3).
scientia non olet · About LEMON Manuals