LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Strut Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Using the outline made by the spray paint or marker, position the transmission rear strut to the drivetrain and front suspension cradle.
    2. Fig 1: Transmission Rear Strut And Bolts
    GM4572779Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  2. Install the NEW transmission rear strut bolt (2) and tighten the bolt to 80 N.m (59 lb ft) plus 45 to 60 degrees.
  3. Install the NEW transmission rear strut to bracket through bolt (1) and tighten to 100 N.m (74 lb ft) plus 120 to 135 degrees.
  4. Install the two piece propeller shaft. Refer to Two-Piece Propeller Shaft Replacement
  5. Remove the jack stand.
  6. Lower the vehicle. Refer to Lifting and Jacking the Vehicle
scientia non olet · About LEMON Manuals