LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Strut Bracket Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Transmission Rear Mount Strut Bracket And Bolts
    GM4891622Courtesy of GENERAL MOTORS COMPANY
  1. Position the transmission rear mount strut bracket (3) to the transmission.
    2. CAUTION:

    Refer to Fastener Caution .

    CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  2. Install the 2 NEW transmission rear mount strut bracket to power transfer unit bolts (1, 2) first and tighten to 100 N.m (74 lb ft) plus 60 - 75 degrees.
  3. Install the 2 NEW transmission rear mount strut bracket to transmission bolts (4, 5) and tighten to 100 N.m (74 lb ft) plus 60 - 75 degrees.
  4. Install the transmission mount strut. Refer to Transmission Mount Strut Replacement (All Wheel Drive) 
scientia non olet · About LEMON Manuals