LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement (Left Side M3U) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Left Transmission Mount And Bolts
    GM4846061Courtesy of GENERAL MOTORS COMPANY
  1. Install the left transmission mount (4) to the vehicle.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the transmission mount to body bolts (5) and tighten to 100 N.m (74 lb ft).
    3. CAUTION:

    Refer to Torque-to-Yield Fastener Warning .

  3. Install the NEW left transmission mount to transmission bolt (1) and initially tighten to 35 N.m (26 lb ft).
  4. Install the NEW left transmission mount to transmission bolt (2) and initially tighten to 35 N.m (26 lb ft).
  5. Install the NEW left transmission mount to transmission bolt (3) and initially tighten to 35 N.m (26 lb ft).
  6. Tighten left transmission mount to transmission bolts (1-3) to 100 N.m (74 lb ft) plus 60 - 75 degrees, using the EN-45059  meter.
  7. Remove the transmission jack.
  8. Install the battery tray. Refer to Battery Tray Replacement .
scientia non olet · About LEMON Manuals