LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement (Left Side M3D/M3H) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Left Transmission Mount And Bolts
    GM4590313Courtesy of GENERAL MOTORS COMPANY
  1. Install the left transmission mount (3) to the vehicle.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the transmission mount to body bolts (1) and tighten to 100 N.m (74 lb ft).
    3. CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  3. Install the NEW left transmission mount to transmission bolts (2) and tighten to 100 N.m (74 lb ft) plus 60 - 75 degrees, using the EN-45059  meter.
  4. Remove the transmission jack.
  5. Install the battery tray. Refer to Battery Tray Replacement .
scientia non olet · About LEMON Manuals