Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the transmission control lever knob retainer (1).
- Reposition Wiring Harness (1)
- Guide the wiring harness through the transmission control lever knob retainer (1).
- Attach the transmission control lever knob extension (1) to the lever knob.
- Attach the transmission control lever boot (1) to the transmission control lever knob.
- Guide the wiring harness through the transmission control lever boot (1).
- Clip the upper boot ring (2) into the bottom of the transmission control lever knob.
- Install Transmission Control Lever Knob (1) @ Transmission Control Lever
- Shift the transmission control lever into "P" position
- Connect Electrical Connector (1)
- Clip the transmission control lever boot (1) into the lever boot bezel (2).
- Release the parking brake.
NOTE:
When installing the transmission control lever knob, a defined snap noise should be audible and a snap effect should be felt. After installation, check the retention of the transmission control lever knob by pulling it upwards with two hands and significant force in an attempt to remove it.
NOTE:
The transmission control lever boot snaps to the lever boot bezel in four locations (arrows): two on the passenger side, one on the driver side, and one on the front side. Before pushing the transmission control lever boot into the lever boot bezel, ensure proper alignment along the edges to avoid visible gaps.