Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the control valve body cover (1).
- Hand start the control valve body cover bolts (1, 2).
- Install the control valve body cover bolts. Tighten the bolts in sequence to 9 N.m (80 lb in).
- Install the body ground cable and wiring harness assembly to the front of transmission.
- Connect the control valve body transmission control module electrical connector (1), then clip the wiring harness to the cover.
- Reposition the transmission fluid cooler outlet pipes (2) to the transmission
- Install the transmission fluid cooler inlet pipe nut (1) to the transmission and tighten to 9 N.m (80 lb in).
- Fill the transmission with correct fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers
- Check transmission fluid level. Refer to Transmission Fluid Level and Condition Check .
- Install the transmission control module bracket. Refer to Transmission Control Module Bracket Replacement
- Install the charge air cooler outlet air tube. Refer to Charge Air Cooler Outlet Air Tube Replacement .
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (KL9) .
- Check for leaks.
NOTE:
The number (1) bolts are stud bolts.
CAUTION:
Refer to Fastener Caution .
NOTE:
Install all control valve body cover bolts and stud bolts by hand then torque all bolts in sequence.