LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Set the park brake and chock the wheels.
    2. Fig 1: Automatic Transmission Range Selector Lever Cable Terminal, Shift Lever And Clamp Bolt
    GM4592602Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect the range selector lever cable terminal (3) from the transmission manual shift lever (2).
  3. Remove the bolt (1) retaining the automatic transmission range selector lever cable to the cable bracket.
  4. Remove the range selector lever cable from the transmission.
  5. Remove the front floor lower console. Refer to Front Floor Lower Console Replacement (Equinox)
    6. Fig 2: Range Selector Lever Cable Components
    GM3825666Courtesy of GENERAL MOTORS COMPANY
  6. Disconnect the range selector lever cable terminal (1) from the transmission control shift lever pin (2).
  7. Push the locking tab (3) rearward in order to release the range selector lever cable (1) from the transmission control assembly (4).
  8. Reposition the front left carpet to access the shift cable grommet, if necessary.
    9. Fig 3: Range Selector Manual Park Release Cable And Cable Grommet Fasteners
    GM3825645Courtesy of GENERAL MOTORS COMPANY
  9. Remove the range selector lever cable grommet fasteners (2).
  10. Remove the range selector lever cable (1) from the vehicle.
scientia non olet · About LEMON Manuals