LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Cable Lever Replacement

Automatic Transmission Range Selector Lever Cable Lever Replacement

WARNING: This page is about a different variant/trim than selected.
Fig 1: Automatic Transmission Range Selector Lever Cable Lever
GM4677668Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Disconnect the electronic transmission range selector manual park release cable from the automatic transmission range selector lever cable lever, then position out of the way. Electronic Transmission Range Selector Manual Park Release Cable Replacement 
  2. Remove Control Valve Body. Refer to Control Valve Body Replacement 
1 Manual Shaft Detent Lever Hub Pin
CAUTION:

Refer to Fastener Caution .


Procedure 
Install the manual shaft detent lever hub pin to correct height.
NOTE:

Install a NEW manual shaft detent lever hub pin.


Specification 
7.9 mm (0.38 in) (a)
2 Manual Shaft
NOTE:

Lubricate the shaft with ATF to prevent damage to the manual shift shaft seal during installation.
3 Manual Shaft Detent Lever Assembly
4 Park Pawl Actuator
scientia non olet · About LEMON Manuals