LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Cable Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Transmission Range Selector Cable Bracket And Bolts
    GM4590554Courtesy of GENERAL MOTORS COMPANY
  1. Install the transmission range selector cable bracket (1).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the transmission range selector lever cable bracket bolts (2) and tighten to 22 N.m (16 lb ft).
  3. Connect the range selector lever cable to the range selector lever cable bracket. Refer to Automatic Transmission Range Selector Lever Cable Replacement 
  4. Check the range selector cable adjustment. Refer to Range Selector Lever Cable Adjustment
scientia non olet · About LEMON Manuals