LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Fluid Pan Drain Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Fluid Fill Cap
    GM4486476Courtesy of GENERAL MOTORS COMPANY
  1. Lower the vehicle.
    2. NOTE:

    If the transmission fluid filler cap cannot be accessed, proceed to the next step in this procedure.

  2. Remove the fluid fill cap (1), if accessible.
  3. Remove the left front wheel and tire assembly. Refer to Tire and Wheel Removal and Installation
    4. Fig 2: Fluid Filler Plug
    GM4487151Courtesy of GENERAL MOTORS COMPANY
  4. Remove the fluid filler plug (1) from the transmission.
  5. Fill the transmission to the proper level with the correct fluid. Refer to Transmission Fluid Level and Condition Check , and Adhesives, Fluids, Lubricants, and Sealers .
  6. Install the fluid fill cap (1), if accessible.
    7. Fig 3: Fluid Filler Plug
    GM4487151Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Component Fastener Tightening Caution .

  7. Install the fluid filler plug (1) to the transmission and tighten to 40 N.m (30 lb ft).
  8. Install the left front wheel and tire assembly. Refer to Tire and Wheel Removal and Installation
scientia non olet · About LEMON Manuals