LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0335 - P26C8) And Symptoms) >> Diagnostic Information And Procedures >> Service Bay Test >> Test Procedure

Test Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • If the Service Bay Test aborts or fails, a DTC will NOT be set.
  • You must not rush the scan tool selections or erroneous results or error messages could occur.
  1. Select the Service Bay Test with the scan tool.
    2. WARNING:

    Refer to Road Test Warning .

  2. Follow the instructions on the scan tool. The EVAP Service Bay Test should complete and should not abort or fail.
    • If the test aborts 

      Correct the condition for running the test, then retest.

      or

    • If the test fails 

      Repair the vehicle for the condition indicated by the failure message, then retest.

    • Go to next step: If the test passes 
      NOTE:

      There are several test parameters displayed and can vary by engine RPO.

  3. Verify that the EVAP Monitor Complete parameter, is set to YES.
scientia non olet · About LEMON Manuals