LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0335 - P26C8) And Symptoms) >> Diagnostic Information And Procedures >> Malfunction Indicator Lamp (MIL) Diagnosis >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
NOTE:

Any MIL requesting DTCs that may be set should be diagnosed first.

  1. Ignition ON.
  2. Verify the parameters listed below do not display Malfunction when commanding the Malfunction Indicator Lamp On and Off with a scan tool.
    • The MIL Control Circuit Low Voltage Test Status
    • The MIL Control Circuit Open Test Status
    • The MIL Control Circuit High Voltage Test Status
    • If Malfunction is displayed 

      Refer to Circuit/System Testing below

    • Go to next step: If Malfunction is not displayed 
  3. Engine running.
  4. Verify the parameters listed below do not display Malfunction when commanding the Malfunction Indicator Lamp On and Off with a scan tool.
    • The MIL Control Circuit Low Voltage Test Status
    • The MIL Control Circuit Open Test Status
    • The MIL Control Circuit High Voltage Test Status
    • If Malfunction is displayed 

      Refer to Circuit/System Testing

    • Go to next step: If Malfunction is not displayed 
  5. Verify the malfunction indicator lamp turns ON and OFF when commanding the Malfunction Indicator Lamp On and Off with a scan tool.
    • If the malfunction indicator lamp does not turn ON and OFF 

      Refer to Circuit/System Testing below

    • Go to next step: If the malfunction indicator lamp turns ON and OFF 
  6. All OK.
scientia non olet · About LEMON Manuals