LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0335 - P26C8) And Symptoms) >> Diagnostic Information And Procedures >> Fuel System Diagnosis >> Circuit/System Testing >> Fuel Pressure Leaks Down

Fuel Pressure Leaks Down

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, relieve the fuel pressure. Refer to Fuel Pressure Relief .
  2. Install the EN-37287  between the chassis fuel feed hose and the high pressure fuel pump.
  3. Open the valve on the EN-37287  .
  4. Ignition ON, command the Fuel Pump Enable On and then Off with a scan tool.
  5. Close the valve on the EN-37287  .
  6. Verify that the scan tool Fuel Pressure Sensor parameter does not decrease greater than 34 kPa (5 PSI) in 1 min.
    • If greater than 34 kPa (5 PSI) 

      Replace the G12 Fuel Pump.

    • Go to next step: If less than 34 kPa (5 PSI) 
  7. Test for a faulty fuel feed front pipe check valve.
    • If a condition exists 

      Replace the fuel feed front pipe.

    • Go to next step: If no condition exists 
  8. Test for a leaking G18 High Pressure Fuel Pump.
    • If a condition exists 

      Replace the G18 High Pressure Fuel Pump.

    • Go to next step: If no condition exists 

      Locate and replace the leaking Q17 Fuel Injector.

scientia non olet · About LEMON Manuals