LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0335 - P26C8) And Symptoms) >> Diagnostic Information And Procedures >> Electronic Ignition System Diagnosis >> Component Testing >> Without Special Tool

Without Special Tool

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle - Off
  2. Swap the two components:T8 Ignition Coil - The original component that set the DTC & Another known good component from the vehicle
  3. Engine - Running
  4. Verify the scan tool parameter:Cylinder 1-4 Current Misfire Counter = Increments - At the original component location the DTC set.
    • If the parameter value does not increment 

      Replace the component:T8 Ignition Coil - The original component that set the DTC

    • Go to next step: If the parameter value increments 
  5. Refer to Circuit/System Testing below