LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0335 - P26C8) And Symptoms) >> Diagnostic Information And Procedures >> DTC P26C8: Chassis Control Module Requested MIL Illumination >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Verify there are no engine control or communication DTCs set.
    NOTE:
    • Do not replace the engine control module for this DTC. DTC P26C8 is an informational DTC.
    • Correct any engine control and communication DTCs before diagnosing chassis control module DTCs.
    • Go to next step: If a DTC is not set 
  2. Verify there are no chassis control module DTCs set.
    • Go to next step: If a DTC is not set 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • Go to next step: If the DTC does not set 
  5. All OK.