Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition On.
Verify that DTC DTC P0097, P0098, P0099, P00F4, P00F5, P00F6, P0102, P0103, P0112, P0113, P0114, P0641, P0651, P0697, P06A3 or P06D2 is not set.
- If any of the DTCs are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- Go to next step: If none of the DTCs are set
Ignition ON.
Verify the following scan tool parameters are within 30°C (54°F) of each other.
- Start-Up IAT Sensor 1
- IAT Sensor 2
- If not within 30°C (54°F)
  Refer to Circuit/System Testing below.
- Go to next step: If within 30°C (54°F)
Engine running, verify the following scan tool parameters are between: -38 and +149°C (-36 and +300°F).
- IAT Sensor 1
- IAT Sensor 2
- If not between: -38 and +149°C (-36 and +300°F)
  Refer to Circuit/System Testing below.
- Go to next step: If between: -38 and +149°C (-36 and +300°F)
Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing below.
- Go to next step: If the DTC does not set
All OK