LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0335 - P26C8) And Symptoms) >> Diagnostic Information And Procedures >> DTC P1400: Cold Start Emission Reduction Control System >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Vehicle OFF, allow the engine to cool to be within the temperatures listed in the Conditions for Running the DTC.
  2. Engine running.
  3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 
    1. Verify that none of the conditions listed below exists with the air intake system:
      • Damage, restriction, or modification
      • Dirty or deteriorating air filter element
      • Crankcase ventilation system for correct operation
      • Water intrusion
      • Vacuum leak and other unmetered air downstream of the mass air flow (MAF) sensor
      • Intake manifold leak
      • If any of the conditions exist

        Repair as necessary.

      • If none of the conditions exist
    2. Verify that none of the conditions listed below exists with the exhaust system:
      • If any of the above conditions exist

        Repair as necessary.

      • If none of the conditions exist
    3. If all of the above conditions test normal, inspect for an engine mechanical condition that could alter the air flow into the combustion chamber. Refer to Symptoms - Engine Mechanical .
    • Go to next step: If the DTC does not set 
  5. All OK.
scientia non olet · About LEMON Manuals