LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0335 - P26C8) And Symptoms) >> Diagnostic Information And Procedures >> DTC P0685-P0687, P0689, P0690 Or P1682: Engine Controls Ignition Relay Control Circuit >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P0685 

The ECM detects that the commanded state of the driver and the actual state of the control circuit do not match for greater than 2 s.

P0686 

The ECM detects a short to ground on the control circuit for greater than 2 s.

P0687 

The ECM detects a short to voltage on the control circuit for greater than 2 s.

P0689 

The ECM detects the engine controls ignition relay feedback circuit is less than 5 V.

P0690 

The ECM detects the engine controls ignition relay feedback circuit is greater than 4 V for greater than 5 s.

P1682 

The ECM detects that the voltage level difference is greater than 3 V between the engine controls ignition relay feedback and ignition 1 signal circuits for greater than 1 s.