Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTC P0010, P0016, P0017, P0018, P0019, P0335, P0336, P0340, P0341, P0345, P0346, P0365, P0366, P0390 or P0391, is not set.
Ignition voltage is greater than 11 V.
Engine is running.
Desired camshaft position is greater than 0 degrees.
Desired camshaft position is not changing greater than 4.5° for at least 1 s.
Both of the desired and actual camshaft position actuator values cannot be greater than 20 degrees or less than 5 degrees.

The DTCs run continuously when the above conditions are met.