Static Test
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, disconnect the harness connector at the Q12 Evaporative Emission Purge Solenoid Valve.
- Test for 10-30 Ω between the control terminal B or 2 and the ignition circuit terminal A or 1.
- If not between 10-30 Ω
Replace the Q12 Evaporative Emission Purge Solenoid Valve.
- Go to next step: If between 10-30 Ω
- If not between 10-30 Ω
- All OK.