LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0335 - P26C8) And Symptoms) >> Diagnostic Information And Procedures >> DTC P0443, P0458 Or P0459: Evaporative Emission (EVAP) Purge Solenoid Valve Control Circuit >> Component Testing >> Dynamic Test

Dynamic Test

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the Q12 Evaporative Emission Purge Solenoid Valve.
  2. Install a 3 A fused jumper wire between the ignition, terminal A or 1 and 12 V. Install a jumper wire between the control terminal B or 2 and ground.
  3. Verify the Evaporative Emission Purge Solenoid Valve turns on & off/clicks and flows vacuum.
    • If it does not turn on & off/click or flow vacuum. 

      Replace the Q12 Evaporative Emission Purge Solenoid Valve.

    • Go to next step: If it does turn on & off/clicks and flows vacuum. 
  4. All OK.
scientia non olet · About LEMON Manuals