LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0335 - P26C8) And Symptoms) >> Diagnostic Information And Procedures >> Alcohol/Contaminants-In-Fuel Diagnosis >> Particulate Contaminants in Fuel Testing Procedure

Particulate Contaminants in Fuel Testing Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Using an approved fuel container, draw approximately 0.5 liter (0.53 qt) of fuel.
  2. Place the container on a level surface for approximately 5 min in order to allow settling of the particulate contamination. Particulate contamination will show up in various shapes and colors. Sand will typically be identified by a white or light brown crystals. Rubber will appear as black and irregular particles.
  3. Observe the fuel sample. If any physical contaminants or water are present, clean the fuel system.
scientia non olet · About LEMON Manuals