Neutral - Engine Running (Hydraulic Circuits With ETRS): Notes
WARNING: This page is about a different variant/trim than selected.
When the gear selector is moved to the Neutral (N) position, the hydraulic and electrical system operation is identical to Park (P) range. However, if Neutral is selected after the vehicle was operating in Reverse (R), the 5-7 reverse solenoid and clutch select control solenoid is commanded OFF and the 1 reverse & 6-7-8-9 solenoid and VFS-S3 - 8 solenoid is commanded ON and the following changes would occur in the hydraulic system.