LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Rear Seat Removal And Installation

Rear Seat Removal And Installation

Fig 1: Rear Seat
GM4599783Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Using a suitable tool, press the button to release the belt from the mini buckle. Rear Center Seat Belt Retractor Replacement
1 Rear Seat Actuator Finish Cover Bolt Cap
2 Rear Seat Bolt (Qty: 11)
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Fold the seat back down.
  2. Remove the front bolts.
  3. Fold the seat bottom up to gain access to the rear bolts.

Tighten 
45 N.m (33 lb ft)
3 Rear Seat

Procedure

  1. Disconnect electrical connections, if applicable.
  2. Disconnect the recliner cable from the release lever cable equalizer. Lift the carpet flap to access, slide the retainer door open and disconnect the cable.
  3. Remove elastic band from the seat belt buckles.
  4. With the aid of an assistant remove the rear seat by lifting and pulling the seat upward to disengage it from the floor.
  5. Separate the rear seats. Rear Seat Separation 
scientia non olet · About LEMON Manuals