Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Corvette Z06, 2D Convertible, Automatic Trans, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All,w/Carbon Ceramic Brake Components,RPO J57 | 2.2 | B | ||
| All,w/o Carbon Ceramic Brake Components,RPO JL9, J55, J56 | 1.8 | B | ||
| Front or Rear,Both Sides,w/Carbon Ceramic Brake Components,RPO J57 | 1.2 | B | ||
| Front or Rear,Both Sides,w/o Carbon Ceramic Brake Components,RPO JL9, J55, J56 | 1.0 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each Additional | 0.2 | B | ||
| One | Includes: Bleed Brakes. | 0.5 | B | |
| Combination Procedure: CALIPER: Overhaul: | ||||
| Front,One,w/Brembo Brakes | Includes: Bleed Brakes. | 1.7 | B | |
| Front,One,w/o Brembo Brakes | Includes: Bleed Brakes. | 1.3 | B | |
| Combination Procedure: CALIPER: Replace: | ||||
| One | Includes: Bleed Brakes. | 0.5 | B | |
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | Correct Rotor lateral runout by indexing or correction plate. | 0.2 | B | |
| Combination Procedure: DISC ROTOR (REMOVED): Refinish: DOES NOT include grind hot spots. | ||||
| Each Additional | 0.3 | B | ||
| One | 0.5 | B | ||
| Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable: | ||||
| Parking Brake Cable Adjuster Disable and Enable | Includes: Disable and enable electronic brake system with use of scan tool or interactive vehicle controls. Includes: Electronic Parking Brake System Calibration. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| Each Side | 0.4 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| Front,Hub Assembly,One Side | 0.5 | B | ||
| Rear,Hub Assembly,One Side | 1.5 | B | ||