Component Testing

Static Test

1. Ignition/Vehicle - Off
2. Disconnect the electrical connector: B55 Hood Ajar Switch
3. B55 Hood Ajar Switch = Closed
4. Test for 2738 to 3350 ohms between the test points: Signal circuit terminal A & Signal circuit terminal B
   • If not between 2738 and 3350 ohms 

     Replace the component: B55 Hood Ajar Switch

   • Go to next step: If between 2738 and 3350 ohms 
5. B55 Hood Ajar Switch = Closed
6. Test for 658 to 806 ohms between the test points: Signal circuit terminal A & Signal circuit terminal C
   • If not between 658 and 806 ohms 

     Replace the component: B55 Hood Ajar Switch

   • Go to next step: If between 658 and 806 ohms 
7. B55 Hood Ajar Switch = Closed
8. Test for 2080 to 2545 ohms between the test points: Signal circuit terminal B & Signal circuit terminal C
   • If not between 2080 and 2545 ohms 

     Replace the component: B55 Hood Ajar Switch

   • Go to next step: If between 2080 and 2545 ohms 
9. B55 Hood Ajar Switch = Open
10. Test for 2738 to 3350 ohms between the test points: Signal circuit terminal A & Signal circuit terminal B
    • If not between 2738 and 3350 ohms 

      Replace the component: B55 Hood Ajar Switch

    • Go to next step: If between 2738 and 3350 ohms 
11. B55 Hood Ajar Switch = Open
12. Test for 2080 to 2545 ohms between the test points: Signal circuit terminal A & Signal circuit terminal C
    • If not between 2080 and 3545 ohms 

      Replace the component: B55 Hood Ajar Switch

    • Go to next step: If between 2080 and 3545 ohms 
13. B55 Hood Ajar Switch = Open
14. Test for 658 to 806 ohms between the test points: Signal circuit terminal B & Signal circuit terminal C
    • If not between 658 and 806 ohms 

      Replace the component: B55 Hood Ajar Switch

    • Go to next step: If between 658 and 806 ohms 
15. All OK.