LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Volt Premier >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 5ET50 (MKV) >> Repair Instructions - On Vehicle >> Transmission Control Replacement (With Base)

Transmission Control Replacement (With Base)

Fig 1: Transmission Control (With Base)
GM4091545Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove Transmission Control Lever Knob. Refer to Transmission Control Lever Knob Replacement 
  2. Remove Front Floor Console. Refer to Front Floor Console Replacement
  3. WARNING:

    After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.

  4. Disconnect Range Selector Lever Cable @ Transmission Control. Refer to Range Selector Lever Cable Replacement 
  5. Disconnect the wiring harness connector and the wiring harness retainers.
1 Transmission Control Lever Housing Bracket Nut (Qty: 5)
CAUTION:

Refer to Fastener Caution


Tighten 
9 N.m (80 lb in)
2 Transmission Control

Procedure

  1. Transfer parts as needed.
  2. After the installation is complete perform a range selector lever cable adjustment. Refer to Range Selector Lever Cable Adjustment .