Hood Adjustment (GMC)

Fig 1: Hood Adjustment (GMC)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Hood CAUTION: Refer to Fastener Caution . Procedure Loosen the hood hinge reinforcement nuts (Qty: 4). Adjust the hood in order to obtain an even gap on both sides between the hood and the fenders, the headlamps and the grille so that the hood is flush with both fenders on the front edge, the front grille and the headlamps. Loosen and adjust the hood primary and secondary latch and the hood bumpers as necessary to obtain the adjustment. Adjustment Hood to front fender (a) 4.0 mm ± 1.0 mm (0.16 in ± 0.04 in) Hood to headlamp (b) 4.0 mm ± 1.0 mm (0.16 in ± 0.04 in) Hood to grille (c) 5.4 mm ± 1.0 mm (0.21 in ± 0.04 in) Tighten 25 N.m (18 lb ft)

Callout

Component Name

Hood

CAUTION:

Procedure

Loosen the hood hinge reinforcement nuts (Qty: 4).
Adjust the hood in order to obtain an even gap on both sides between the hood and the fenders, the headlamps and the grille so that the hood is flush with both fenders on the front edge, the front grille and the headlamps.
Loosen and adjust the hood primary and secondary latch and the hood bumpers as necessary to obtain the adjustment.
Adjustment
- Hood to front fender (a) 4.0 mm ± 1.0 mm (0.16 in ± 0.04 in)
- Hood to headlamp (b) 4.0 mm ± 1.0 mm (0.16 in ± 0.04 in)
- Hood to grille (c) 5.4 mm ± 1.0 mm (0.21 in ± 0.04 in)

Tighten
25 N.m (18 lb ft)