Front Side Door Weatherstrip Replacement - Body Side

Fig 1: Front Side Door Weatherstrip - Body Side

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Open the door to the full open position. Remove the front side door sill garnish molding. Refer to Front Side Door Sill Garnish Molding Replacement . Remove the instrument panel fuse block access hole cover. Refer to Instrument Panel Fuse Block Access Hole Cover Replacement (Chevrolet / GMC)Instrument Panel Fuse Block Access Hole Cover Replacement (Cadillac) . Remove the center pillar upper trim panel. Refer to Center Pillar Upper Trim Panel Replacement .
1	Front Side Door Weatherstrip to Body Side Procedure Start at the rear upper corner of the door opening and pull the weatherstrip away from the door opening flange. Position the weatherstrip in the upper corner of the center pillar. Working downward along the front edge, install the weatherstrip on the door opening flange ensuring that the carrier is fully seated in the corners. Ensure that the weatherstrip is seated on the entire door opening flange. NOTE: Inspect the door to ensure a proper seal after the weatherstrip has been replaced.

Callout

Component Name

Preliminary Procedures

Front Side Door Weatherstrip to Body Side

Procedure

Start at the rear upper corner of the door opening and pull the weatherstrip away from the door opening flange.
Position the weatherstrip in the upper corner of the center pillar.
Working downward along the front edge, install the weatherstrip on the door opening flange ensuring that the carrier is fully seated in the corners.
Ensure that the weatherstrip is seated on the entire door opening flange.

NOTE:

Inspect the door to ensure a proper seal after the weatherstrip has been replaced.