Circuit/System Verification
- Ignition - On / Vehicle - In Service Mode
- Verify the scan tool parameter: Engine Oil Pressure Sensor=0 kPa (0 PSI)
- If not the specified state
Refer to Circuit/System Testing
- If the specified state
- If not the specified state
- Verify the engine has the correct oil level and the correct oil pressure before continuing with this diagnostic.
- Engine Running
- Verify the scan tool parameter: Engine Oil Pressure Sensor=CH-48027
Digital Pressure Gauge
- If not the specified state
Refer to Circuit/System Testing
- If the specified state
- If not the specified state
- Verify the scan tool parameter: Engine Oil Pressure Sensor=Engine Oil Pressure - Gauge @ P16 Instrument Cluster
- If not the specified state
Test or replace the component: P16 Instrument Cluster
- If the specified state
- If not the specified state
- All OK.