LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Engine Controls And Fuel - 1.6L (LWC) - DTC P0010 To DTC P0238) >> Diagnostic Information and Procedures >> DTC P0121-P0123, P0222, P0223, P16A0-P16A2, or P2135 >> Repair Verification

Repair Verification

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install any components that have been removed or replaced during diagnosis.
  2. Perform any adjustments, programming or setup procedures that are required when a component is removed or replaced.
  3. Clear the DTCs with a scan tool.
  4. Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down.
  5. Ignition ON.
  6. Verify the Throttle Position Sensors 1 and 2 Agree/Disagree parameter displays Agree while performing the Throttle Sweep Test with a scan tool.
    • If Agree is not displayed 

      Test or replace the Q38 Throttle Body Assembly.

    • Go to next step: If Agree is displayed 
  7. If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not set.
    • Go to next step: If a DTC does not set 
  8. All OK.
scientia non olet · About LEMON Manuals