LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Engine Controls And Fuel - 1.6L (LWC) - DTC P0010 To DTC P0238) >> Diagnostic Information and Procedures >> DTC P00EA-P00EC >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Intake Manifold and Air Temperature sensor

  1. Ignition OFF, disconnect the harness connector at the B65 Intake Manifold and Air Temperature sensor.
    2. NOTE:

    A thermometer can be used to test the sensor off the vehicle.

  2. Test the IAT sensor 3 by varying the sensor temperature while monitoring the sensor resistance. Compare the readings with the Temperature Versus Resistance - Intake Air Temperature Sensor appropriate table for the sensor. The resistance values should be in range of the table values.
    • If not within the specified range 

      Replace the B65 Intake Manifold and Air Temperature sensor.

    • Go to next step: If within the specified range 
  3. All OK.
scientia non olet · About LEMON Manuals