Conditions for Running the DTC
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
P0089, P228C, or P228D
- DTC P0016, P0017, P0090, P0091, P0092, P00C8, P00C9, P00CA, P0111, P0112, P0113, P0114, P0117, P0118, P0119, P0128, P0192, P0193, P0335, P0336, P0340, P0341, P0365, P0366, P0627, P0628, P0629, or P1682 are not present.
- Battery voltage is greater than 8 V.
- The engine has been running for greater than or equal to 10 s.
- Low side fuel pressure is greater than 300 kPa (44 PSI).
- Barometric (BARO) pressure is greater than or equal to 70 kPa.
- Intake air temperature (IAT) is warmer than or equal to -10°C (14°F).
- Fuel temperature is between -10°C and +132°C (14°F and 270°F).
- Vehicle is not in a low fuel condition
- The DTCs run continuously when the above conditions are met.
P00C6
- DTC P0016, P0017, P0090, P0091, P0092, P00C8, P00C9, P00CA, P0111, P0112, P0113, P0114, P0117, P0118, P0119, P0128, P0192, P0193, P0335, P0336, P0340, P0341, P0365, P0366, P0627, P0628, P0629, or P1682 are not present.
- Ignition voltage is greater than 8 V.
- Engine coolant temperature is less than 65°C (149°F).
- Low side fuel pressure is greater than 300 kPa (44 PSI).
- Vehicle is not in a low fuel condition
- The diagnostic runs once for each engine start.
P2C1E, P2C1F or P2C20
- Battery voltage is greater than 11 V.
- Low side fuel pressure is greater than 300 kPa (44 PSI).
- Barometric (BARO) pressure is greater than or equal to 70 kPa.
- Intake air temperature (IAT) is warmer than or equal to -10°C (14°F).
- Fuel temperature is between -10°C and +132°C (14°F and 270°F).
- Catalyst Warm up enabled