LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Engine Controls And Fuel - 1.6L (LWC) - DTC P0010 To DTC P0238) >> Diagnostic Information and Procedures >> DTC P0033-P0035 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, Verify the parameters listed below do not display Malfunction when commanding the Turbocharger Bypass Solenoid Valve between Active and Inactive with a scan tool:
    • Turbocharger Bypass Solenoid Valve Control Circuit Low Voltage Test Status
    • Turbocharger Bypass Solenoid Valve Control Circuit Open Test Status
    • Turbocharger Bypass Solenoid Valve Control Circuit High Voltage Test Status
    • If Malfunction is displayed 

      Refer to Circuit/System Testing.

    • Go to next step: If Malfunction is not displayed 
  2. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  3. Verify DTC P0033, P0034 or P0035 does not set.
    • If a DTC sets 

      Refer to Circuit/System Testing

    • Go to next step: If a DTC does not set 
  4. All OK