Automatic Headlamp Leveling RPO TR7

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

The Automatic Headlamp Leveling Systems consist of the following components:

Ballast module - left
Ballast module - right
Headlamp leveling actuator - left
Headlamp leveling actuator - right
Headlamp control module
Headlamp leveling sensor - front
Headlamp leveling sensor - rear

The automatic headlamp leveling system automatically maintains the vertical alignment of the headlamps when the vehicle load and driving conditions change. The headlamp control module receives inputs from the front and rear headlamp leveling sensors to determine vehicle pitch. The headlamp leveling sensors send an output to the headlamp control module as the vehicle suspension compresses and rebounds. The headlamp control module calculates the difference in vehicle pitch and sends a command to the (HID) ballast. The ballast then drive the headlamp leveling actuators to the position commanded by the headlamp control module. The headlamp leveling system also monitors the performance of the HID bulb and ballast. When the headlamp switch is placed in the ON position the headlamps will go down, and then back up to the center position.