Easy Entry Seat Operation

When the seat backrest is manually folded forward, the easy entry switch located in the seat back is closed signaling the folding top control module the easy entry command. In response to this signal, the control module applies battery voltage through the seat easy entry motor forward control circuit and ground through the seat easy entry motor rearward control circuit to the seat easy entry motor. The motor runs at a high speed rate in order to drive the entire seat forward until the seat most forward position is reached. When the seat backrest is manually moved back to the upright position, the easy entry switch is opened signaling the folding top control module to move the entire seat rearward. The control module applies battery voltage and ground on the opposite circuits causing the motor to run at a high rate of speed in the opposite direction until the seat reaches its original position.