LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Rear Suspension System) >> Repair Instructions >> Rear Axle Bushing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Use of eye goggles is necessary to prevent personal injury.

NOTE:

Rear axle bushings must ONLY be replaced pairwise.

  1. Remove the rear axle. Refer to Rear Axle Replacement .
  2. With the aid of a second mechanic, place the rear axle onto a work bench.
  3. GM2192183

    Mark the installation position (1) for the rear axle bushing (2) on the rear axle using a permanent marker.

    Use upper gap of bushing for alignment.

  4. Place a drip pan under the axle.
  5. GM2192185

    Drill 8 times all around through rubber (1) bushing with a 10 mm (0.4 in) drill.

  6. GM2192191

    Carefully jigsaw around the bushing core (1) of the rear axle bushing. Use the lowest bore (2) to insert saw.

  7. Remove the bushing core from the bushing.
  8. GM2191230

    Remove the bushing (1), using the CH-48377-1  chisel (2) and a hammer.

scientia non olet · About LEMON Manuals