LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Upper Ball Stud Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front brake shield. Refer to Front Brake Shield Replacement .
  3. GM2844698

    Remove and DISCARD the steering knuckle upper camber adjust bolt (3) and nut (2).

  4. Remove and DISCARD the steering knuckle lower camber adjust bolt (4) and nut (1).
  5. GM2844697

    Remove and DISCARD the steering knuckle nut (1).

  6. GM2844695
    NOTE:

    The CH-50823  support bearing remover contains two different spindle mountings for the right side and left side. They can be identified by an engraved "R" and "L".

    Install the CH-50823  support bearing remover (1) to the steering knuckle (3). Fix the CH-50823  support bearing remover (1) through the lower wheel bearing holes with the supplied bolts.

  7. Turn the spindle (2) of the CH-50823  support bearing remover (1) until the steering knuckle upper ball stud (4) cone detaches from the steering knuckle (3).
  8. Remove the CH-50823  support bearing remover (1) from the steering knuckle (3).
  9. GM2844696

    Remove the steering knuckle upper ball stud (2) from the steering knuckle (1) and the front suspension strut yoke (3).

scientia non olet · About LEMON Manuals