Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Turn the front wheels to the straight forward position and secure the steering wheel from moving.
Remove the lower steering intermediate shaft bolt (1).
Disconnect the intermediate steering shaft from the steering gear.
Raise and support the vehicle. Lifting and Jacking the Vehicle .
Remove the front tire and wheel assemblies. Tire and Wheel Removal and Installation .
{ If equipped } Front Compartment Insulator Replacement - Remove
{ If equipped } Engine Shield Replacement - Remove
Exhaust Front Pipe Replacement - Remove
Front Stabilizer Shaft Link Nut(2) - Remove and DISCARD
Stabilizer Shaft Link(1)@Stabilizer Shaft - Disconnect
Clip(1) - Remove[4x]
Clip(1) - Remove[4x]
Front Transmission Mount Through Bolt(1) - Remove
Rear Transmission Mount Bracket Bolt(2) - Remove
Support the drivetrain and front suspension frame with a suitable hydraulic jack.
Remove 2 rear suspension frame bolts (2).
Remove rear frame reinforcements (1).
Carefully lower the front suspension frame assembly enough to gain access to the stabilizer shaft insulator bolts. Bent engine side cover aside.
Remove and DISCARD the 4 front stabilizer shaft insulator clamp bolts (1).

NOTE:
The stabilizer shaft insulator is serviced with the stabilizer shaft. It is NOT serviced separately.
Remove the stabilizer shaft.