Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Install the stabilizer shaft.

WARNING:

Refer to Torque-to-Yield Fastener Warning .

CAUTION:

Refer to Fastener Caution .

Install the 4 NEW front stabilizer shaft insulator clamp bolts (1). Tighten the stabilizer shaft bolts a first pass to 22 N.m (16 lb ft).
Tighten the 4 NEW front stabilizer shaft insulator clamp bolts (1) a final pass to an additional 30 degrees, using the EN-45059 angle meter.
Raise the frame (1) carefully, using a suitable hydraulic jack.
Install the 2 frame reinforcements (1).
Install the 2 frame rear bolts (2) and tighten to 160 N.m (118 lb ft).
Install the front transmission mount bolt (1) and tighten to 58 N.m (43 lb ft).
Install the rear transmission mount bracket bolt (2) and tighten to 100 N.m (74 lb ft).
Install and tighten 4 fasteners (1) of engine side cover on both sides.
Install and tighten 4 fasteners (1) of front engine compartment cover.
Install the front compartment insulator, if equipped Front Compartment Insulator Replacement .
Install the engine shield, if equipped. Refer to Engine Shield Replacement .
Install the exhaust front pipe. Refer to Exhaust Front Pipe Replacement .
Install and tighten NEW lower stabilizer link shaft nut (2) on both sides to 65 N.m (48 lb ft).
Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.
Install the steering intermediate shaft to the steering gear
Install the lower steering intermediate shaft bolt (1) and tighten to 34 N.m (25 lb ft).
Ensure that the steering wheel and the front wheels are still in straight forward position.
Measure and adjust the wheel alignment. Wheel Alignment Measurement .