LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Front Suspension System) >> Repair Instructions >> Front Lower Control Arm Bushing Replacement (GNB, Rear)

Front Lower Control Arm Bushing Replacement (GNB, Rear)

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
GM2027753
Callout Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the front compartment insulator. Refer to Front Compartment Insulator Replacement
  4. Remove the lower control arm. Refer to Lower Control Arm Replacement .
1 Lower Control Arm Rear Bushing Bolt
2 Lower Control Arm Rear Bushing
WARNING:

Refer to Torque-to-Yield Fastener Warning .

CAUTION:

Refer to Fastener Caution .

Procedure

  1. Install and hand tighten the NEW bushing bolt. Do NOT reuse old bolt.
  2. Install lower control arm to the vehicle. Refer to Lower Control Arm Replacement 
  3. Support the lower control arm with a hydraulic jack and lift the control arm into the neutral position.
  4. Tighten lower control arm bushing bolt.

Tighten 
55 N.m (41 lb ft) + 45 - 60°
Special Tools 
EN-45059  Torque Angle Sensor Kit
For equivalent regional tools. Refer to Special Tools .
scientia non olet · About LEMON Manuals