LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Tire Pressure Monitoring System) >> Repair Instructions >> Tire Pressure Indicator Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Tire and Wheel Removal and Installation .
  3. GM3903213
    NOTE:

    Never fit the tire pressure indicator sensor on unapproved wheel rims.

    NOTE:

    Whenever the tire will be removed from the rim, install a new dust cap, valve core, nut and seal. Do not reuse the old parts.

    Dust Cap (1) - Remove and DISCARD

  4. Valve Core (2) - Remove and DISCARD
  5. Dismount the tire from the rim on the valve side.
  6. GM3970755

    Nut(1) - Remove and DISCARD

  7. Remove the tire pressure sensor.(2)
  8. GM3970756
    NOTE:

    Change the seal with a plastic tool.

    Seal(1) - Remove and DISCARD

scientia non olet · About LEMON Manuals