LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Parking Assistance Systems) >> Diagnostic Information and Procedures >> DTC B096C or B096D >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify that DTC B1405 is not present.
    • Go to next step: If the DTC does not set 
  3. Verify that DTC B096C 01 or B096D 01 is not present.
    • If the DTC is set 

      Check the appropriate sensor for contamination with mud, ice or snow. If no contamination is diagnosed, refer to Circuit/System Testing.

    • Go to next step: If the DTC does not set 
  4. Verify that DTC B096C 3A or B096D 3A is not present.
    • If the DTC is set 

      Replace the appropriate sensor with a sensor by correct sensor type.

    • Go to next step: If the DTC does not set 
  5. Verify that DTC B096C 21 or B096D 21 is not present.
    • If the DTC is set 

      Check the appropriate sensor for contamination with mud, ice or snow. If no contamination is diagnosed, replace the appropriate sensor.

    • Go to next step: If the DTC does not set 
  6. All OK.
scientia non olet · About LEMON Manuals