LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Engine Controls And Fuel - 1.6L (LWC) - DTC P0243 To DTC P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P111E >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Vehicle OFF, disconnect the harness connector at the B34 Engine Coolant Temperature Sensor.
  2. Test the ECT sensor by varying the sensor temperature while measuring the sensor resistance. Compare the readings with the Temperature Versus Resistance - Engine Coolant Temperature Sensor table. The resistance values should be in range of the table values.
    • If not within the specified range 

      Replace the B34 Engine Coolant Temperature Sensor.

    • Go to next step: If within the specified range 
  3. Test for infinite resistance between each terminal and the sensor housing.
    • If less than infinite resistance 

      Replace the B34 Engine Coolant Temperature Sensor.

    • Go to next step: If infinite resistance 
  4. All OK.
scientia non olet · About LEMON Manuals